Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateStyles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
See the difference
Before
After
Before
After
Before
AfterHow Much Does Gate Installation Cost in Peoria?
A typical new gate installation in Peoria costs $2,400 to $7,800 for a residential driveway gate with an automatic opener. A manual swing gate on an existing fence line runs $1,200 to $3,200, while a full custom automatic system with new posts, loops and intercom can reach $9,000 or more. The written estimate sets your final price, and we give that estimate free after we look at your driveway, fence line and power source.
That range is wide because gate installation isn’t one job. It’s posts set in desert soil, panels hung to swing or slide true, and an operator wired and tuned to move a gate that weighs a few hundred pounds. We specialize exclusively in gates – it’s all we do – so the number we quote reflects the actual work, not a padded catch-all.
Key Takeaways
- Residential automatic driveway gate installation in Peoria typically lands between $2,400 and $7,800.
- Manual gates cost less because there’s no operator, wiring or safety sensor to integrate.
- Post footing depth, soil conditions and power runs are the three biggest cost drivers on a Peoria property.
- Our technicians have up to 11 years of experience, and they service equipment from nine gate and access-control brands.
- Estimates are free, and the price is set per job by the written estimate.
Gate Installation Cost Breakdown (2026)
Here’s how the money breaks down on a Peoria installation. These are typical estimated ranges for materials and labor combined, and your written estimate is what sets the final figure.
| Line Item | Typical Range | What It Covers |
|---|---|---|
| Manual swing gate (single leaf) | $1,200 – $3,200 | Gate panel, hinges, latch, and posts set to proper footing depth |
| Manual slide gate | $1,800 – $4,200 | Sliding panel, track or cantilever hardware, and guide posts |
| Dual swing driveway gate (manual) | $2,600 – $5,400 | Two leaves, center latch, and heavier hinge hardware |
| Automatic swing gate with opener | $3,800 – $7,800 | Gate, posts, operator, control board, and safety sensors |
| Automatic slide gate with opener | $4,200 – $8,600 | Sliding gate, track, operator, control board, and safety sensors |
| Operator and electrical wiring | $900 – $2,400 | Power run, conduit, and hookup to the operator |
| Safety loops and vehicle detectors | $400 – $1,100 | In-ground loop detectors so the gate doesn’t close on a vehicle |
| Keypad or intercom access | $300 – $950 | Entry keypad, intercom, or remote receiver integration |
| Custom fabrication (oversized or arch-top) | $1,500 – $4,500 added | Non-standard panel widths, heights, and design work |
What pushes cost up: a wide driveway that needs a heavier operator, a long power run from the house out to the gate corner, or an arched or oversized panel that has to be fabricated. What pulls it down: reusing sound existing posts, keeping a manual gate manual, and choosing a standard panel width that doesn’t need custom work. Whether your opener is a LiftMaster or a Mighty Mule, we quote the operator and the wiring together so there’s no surprise line item later.
One thing Peoria homeowners often don’t anticipate: an automatic gate needs a licensed electrician for the power connection in most cases. That’s a separate trade, and we’re upfront when a job needs one. We handle the gate, the operator, the control board and the sensors; the high-voltage hookup gets done by someone qualified to do it.
What Affects Gate Installation Pricing in Peoria
Peoria isn’t a generic market. Caliche-heavy soil, wide suburban driveways and the fact that many properties back onto open desert or wash corridors all shape what an installation costs here.
- Post footing depth and soil. Gate posts go to proper footing depth, and in Peoria’s hard desert soil that can mean more digging time and sometimes a small concrete pour. Rocky ground slows a crew down, and that labor shows up in the quote.
- Driveway width and gate span. Peoria driveways in neighborhoods like Vistancia and the newer builds off Lake Pleasant Parkway are often wide enough for two vehicles or an RV. A wider span means a heavier gate and a stronger operator, and both cost more.
- Automatic versus manual. Adding an operator, a control board and safety sensors is usually the single biggest jump in the total. A manual gate avoids all of that wiring.
- Power availability at the gate corner. If there’s already an outlet or a conduit stub near the gate, the electrical run is short. If the power has to come from the far side of the house, the run gets longer and the cost climbs.
- Brand and access hardware. A basic opener and a keypad sit at the low end. Intercom integration, loop detectors and multi-remote access systems push the price up. We work with LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite and Mighty Mule, so you can match the operator to your budget and property type.
- Custom design and finish. Arch tops, ornamental panels, non-standard heights and matching an existing fence style all add fabrication time. A plain standard panel is the cheapest path.
- Commercial and HOA access points. Property managers and HOAs with a shared entry need equipment rated for higher traffic – DoorKing and similar commercial-grade systems – plus vehicle detectors and access control. That’s a different price bracket than a single residential driveway.
If you want the full picture of what gate work looks like on a Peoria property, our Peoria page covers the local service side, and our main gate repair Peoria page covers repair and diagnostics when an existing gate is failing rather than being replaced.
How to Save on Gate Installation
There’s no magic discount on gate installation – the savings come from smart choices about what you actually need, not from hunting for the lowest bidder. A cheap quote that skips the safety loops or undersizes the operator costs more in the long run.
- Keep a manual gate manual if you can. If you don’t truly need an automatic opener, a manual gate saves the operator, the control board, the sensors and the power run. That’s often $1,500 or more.
- Reuse sound posts and fence line. If your existing posts are solid and properly set, hanging a new gate on them avoids new footings. We’ll tell you honestly whether they’re reusable.
- Choose a standard panel width. Standard sizes avoid custom fabrication. A non-standard width means a custom build, and that’s added cost.
- Plan the power run before you buy the operator. Deciding where the gate sits with the power source in mind shortens the electrical run and saves on conduit and labor.
- Match the operator to the gate weight, not to the brochure. An oversized operator on a light gate wastes money; an undersized one wears out fast. We spec it correctly so you’re not paying twice.
- Bundle the access hardware. Adding a keypad or receiver at the same time as the installation is cheaper than a separate visit later, because the technician is already on-site wiring the operator.
The estimate itself is free, and it’s the best place to find savings because we can see exactly what your property needs. Call (855) 574-0402 and we’ll walk your driveway, gate corner and power source and put a written number in front of you.
Manual or automatic – which should you budget for?
Most Peoria homeowners who install a new gate on a driveway they use daily end up going automatic. The convenience is real, but it’s the operator, wiring and safety sensors that drive the price. For a side yard, a back gate or a low-traffic access point, a manual gate keeps the budget down and needs no power. We quote both so you can compare the real numbers side by side rather than guessing.
FAQs – Gate Installation Cost
How much does an automatic driveway gate cost to install in Peoria?
Expect $3,800 to $7,800 for a standard residential automatic swing gate, or $4,200 to $8,600 for a slide gate, including the gate, posts, operator, control board, safety sensors and wiring. Custom sizes, long power runs and intercom integration push the number toward the top or past it. Call (855) 574-0402 for an exact quote – estimates are free.
Is it cheaper to install a new gate or repair the old one?
Repair is almost always cheaper when the existing gate and posts are structurally sound – often a fraction of a new installation. Replacement makes more sense when the posts are failing, the panel is bent or rusted through, or the operator is beyond repair. We diagnose the existing gate first and tell you which side of that line you’re on before you commit to a number. Electric gate acting up? We diagnose the motor, board and sensors – not just the obvious.
Do I need a permit to install a gate in Peoria?
Many gate installations don’t require a permit, but rules around fences, walls, height limits and electrical connections vary. Check with the city’s building department before the work starts, especially for anything involving a new power connection. We can point you toward what to ask; the city makes the call.
How much does gate installation cost for an HOA or commercial access point?
Commercial and HOA entry systems typically start around $6,000 and can run well into five figures depending on traffic volume, access control and the number of entry points. Shared entries need commercial-grade operators, vehicle detectors and access hardware built for constant use. Property managers and HOAs get the same free on-site estimate as a homeowner.
Can you install a gate the same day I call?
Simple manual gate installs can sometimes be scheduled fast, and same-day service is available for repairs and smaller jobs. A full automatic install with new posts and a power run is usually a scheduled job rather than a same-day one. Call (855) 574-0402. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
What gate brands can you install and service?
We install and service LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite and Mighty Mule. That range means we can match the operator to your gate weight, your power situation and your access needs rather than forcing one brand onto every driveway. Nine brands. One specialist. No runaround.
How long does a gate installation take?
A manual gate on existing posts can be a single visit. An automatic installation with new posts, an operator and a power run is typically a full-day job, and longer if the power connection needs an electrician or the panel is custom. Custom fabrication adds lead time before the install begins. We give you a realistic timeline with the written estimate.
What Happens When You Call
You call, we ask about your driveway, your gate opening, whether you want manual or automatic, and what access hardware you need. Then a technician comes out, looks at the soil, the posts, the power source and the gate corner, and puts a written estimate in your hands. No guesswork, no surprise line items. If the job needs an electrician for the high-voltage hookup, we’ll tell you that upfront.
We’re a gate specialist, not a general fencing or garage-door company that dabbles. One call covers installation, repair and everything in between, and our technicians have up to 11 years of experience working with openers, control boards, loop detectors and access hardware across nine major brands. Whether it’s a simple manual swing gate or a full automatic access system, we quote the whole job accurately the first time.
Call (855) 574-0402 for a free estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. We’re closed Saturday, so a call that day books into the next opening on Sunday.
Written by the team at Gate Repair Peoria.
Pricing reflects the Peoria market as of 2026. Gate Repair Peoria offers free estimates – call (855) 574-0402.
What Our Customers Say
"We had a hydraulic arm leaking fluid onto the driveway. Replaced, cleaned up the stain as best he could, and it's been dry for months."
- Miguel Mendoza"Our slide gate had been dragging for months and getting worse. Turned out the chain was stretched and one of the guide rollers had seized. Both replaced, and he adjusted the limits so it stops properly at both ends now."
- Maya Shah"Repair is holding. He was quite a bit later than the window I was given, and nobody called me about it, I had to call them. The work itself was done well once he got here."
- Eric Mercer